Loading Trays 1 And 2 - Xerox WorkCentre 5790 User Manual

Trays 1 and 2

Loading Trays 1 and 2

If Tray 1 or Tray 2 is set as a Dedicated tray, the media requested must be loaded in the tray and the
settings cannot be adjusted.
CAUTION: A problem will occur if a tray is opened while it is being used to feed media. Do not
open Tray 1 if Tray 2 is open.
1. Open the tray.
2. Place the media in the tray. Media must be positioned
against the left side of the tray.
• Load pre-printed paper face-down and with the
top towards the front of the device.
• Load hole punched paper with the holes on the
left edge.
Paper must not be loaded above the maximum fill line.
3. Make sure that the paper guides just touch the paper.
• To position the right side guide, squeeze the
clamp mechanism and slide the guide to touch the right edge of the media.
• To position the rear guide, squeeze the clamp mechanism and slide the guide to touch the
rear edge of the media.
4. Close the paper tray.
The paper settings for the tray are displayed on the touch screen.
5. Confirm or change the settings, as required.
224 WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
Paper and Media