Consumables Management; Service Plan - Xerox WorkCentre 5790 User Manual

Consumables Management

Select the Consumables Management option to access the following settings:
•

Service Plan

on page 257
• Feed Roll Replacement
• Ozone Filter Replacement
• Xerographic Reordering
• Fuser Module Replacement
• Toner Cartridge Reordering
Service Plan
This option is used to change your Xerox Service Plan. To change the plan, contact the Xerox Support
Center with your machine serial number. Xerox will provide you with a Service Plan Authorization
Number. Enter the number and select the Enter button.
Feed Roll Replacement
This option provides notification of how many days the Document Feeder Feed Roll (R6) has until it
reaches the end of its life.
Ozone Filter Replacement
The Ozone Filter (R5) is a customer replaceable unit. This option provides notification of how many
days the Ozone Filter (R5) has until it reaches the end of its life. The Ozone Filter (R5) has the same life
as the Fuser Module (R3) and is supplied with the Fuser Module (R3). Always replace the Ozone Filter
(R5) at the same time as the Fuser Module (R3).
Xerographic Reordering
The Xerographic Module (R2) has a specific life expectancy and will occasionally need to be replaced to
maintain good image quality. This option is used to set the interval in days between the appearance of
the "Re-order" message and the day that the new module should be installed.
• Reorder Notification enter the number of days notification required between 1 and 25.
• Cancel Current Notifications once the re-order message has appeared and you have placed your
order for a new module, you can switch the message off by selecting this button.
Fuser Module Replacement
The Fuser Module (R3) has a specific life expectancy and will occasionally need to be replaced to
maintain good image quality. This option is used to set the interval in days between the appearance of
the "Re-order" message and the day that the new module should be installed.
• Reorder Notification enter the number of days notification required between 1 and 25.
• Cancel Current Message(s) once the re-order message has appeared and you have placed your
order for a new module, you can switch the message off by selecting this button.
on page 257
on page 257
on page 257
on page 257
on page 258
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
Administration and Accounting
Device Settings
257