Paper and Media
3. Stack the paper against the left-rear corner of the tray.
• Insert letterhead and pre-printed paper face down with the top edge toward the front of the tray.
• Load hole-punched paper with the holes to the left.
Note: Do not load the paper above the maximum fill line. Overfilling the tray can cause paper jams.
4. Slide the tray back into the printer.
5. At the control panel, select the correct paper type and color.
• If letterhead paper is loaded in the printer, for type, select L L e e t t t t e e r r h h e e a a d d .
• If pre-printed paper is loaded in the printer, for type, select P P r r e e - - p p r r i i n n t t e e d d .
6. To confirm the settings, touch C C o o n n f f i i r r m m .
LO A D I N G PA P E R I N T H E BY PA S S T R AY
The Bypass Tray supports the widest variety of media types. The tray is intended primarily for small-quantity jobs
that use special media.
To load paper in the Bypass Tray:
212
Xerox
®
AltaLink
®
B8145/B8155/B8170 Series Multifunction Printer User Guide