Configuring EtherChannel Using LACP
Configuring EtherChannel Using LACP
These sections describe how to configure EtherChannel using LACP:
•
•
•
•
•
•
•
•
•
•
•
Note
Before you configure the EtherChannel, see the
Restrictions" section on page
Specifying the EtherChannel Protocol
The default protocol is PAgP.
Note
Note
You can specify only one protocol, PAgP or LACP, per module.
To specify the EtherChannel protocol, perform this task in privileged mode:
Task
Specify the EtherChannel protocol.
This example shows how to specify LACP for modules 2 and 3:
Console> (enable) set channelprotocol lacp 2,3
Mod 2 is set to LACP protocol.
Mod 3 is set to LACP protocol.
Console> (enable)
Use the show channelprotocol command to display the protocols for all modules.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
6-18
Specifying the EtherChannel Protocol, page 6-18
Specifying the System Priority, page 6-19
Specifying the Port Priority, page 6-19
Specifying an Administrative Key Value, page 6-19
Changing the Channel Mode, page 6-20
Specifying the Channel Path Cost, page 6-21
Specifying the Channel VLAN Cost, page 6-21
Clearing LACP Statistics, page 6-21
Displaying EtherChannel Traffic Utilization, page 6-21
Disabling an EtherChannel, page 6-22
Displaying Spanning Tree-Related Information for EtherChannels, page 6-22
6-3.
Chapter 6
Configuring Fast EtherChannel and Gigabit EtherChannel
"EtherChannel Configuration Guidelines and
Command
set channelprotocol [pagp | lacp] mod
78-15908-01