Konica Minolta Fujitsu fi-6800 Operating Manual page 63

Chapter 4 How to Use the Operator Panel
Display
Error code
Error
Message
Error code
Error
Message
Description
Indicates that a recoverable error
occurred during scanning.
Error codes beginning with the
letter "J" or "U" are displayed.
For more details about the
errors, refer to "Temporary
Errors" (page 143).
You can clear the error display
by pressing the [Clear/Back] or
the [Stop] button.
Note that if the error is "Paper
jam", the message disappears
after a certain amount of time
elapses with no documents
([Ready] status) in the scanner.
Indicates that a device error
occurred during initialization or
scanning.
Error codes beginning with the
letter "E", "F", "C", "H", "A" or "L"
are displayed.
For more details about the
errors, refer to "Device Errors"
(page 146).
When this indication of a device
error is displayed, turn the power
off then back on from the main
power switch.
If the indication continues to
appear after turning the power
back on, contact your FUJITSU
scanner dealer or an authorized
FUJITSU scanner service
provider.
Display Description
When the scanner has not been
in operation for the set sleep
interval, it enters power saving
mode.
Press any button on the operator
panel to return to the previous
screen.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
63