Konica Minolta Fujitsu fi-6800 Operating Manual page 95

Chapter 5 Various Ways to Scan
5
Repeat step 4 until all the documents are scanned.
Scanning can be stopped immediately by pressing the
[Counter Reset] button on the operator panel.
Scanning stops when no document is loaded on the
hopper after the time specified in the Software
Operation Panel.
The scanner waits for the period of manual feed
timeout even when there is no document left on the
hopper.
The timeout period for manual feeding can be
configured on the operator panel or in the Software
Operation Panel.
To release Manual Feed mode, bring the pick roller
unit back down to its original position. Put your finger
on the tab in the center and push it down.
Pick Roller Unit
■ Scanning in Continuous Feed mode
1
Open the hopper if it is closed.
For information on how to open the hopper, refer to
Closing the Hopper" (page 19).
2
Configure by selecting [Main Menu]
[1: Manual (Continuous)] on the operator panel.
For more details about the setting, refer to
65).
The hopper moves up to the feeding position.
Make sure that there is no document left on the
hopper.
Be careful not to have your fingers or anything else
caught when the hopper moves up.
You can also set it to [Manual (Continuous)] from the
[Hopper Level] screen via shortcut key. For details about
the setting, refer to "1.7 Setting the Loading Capacity of
the Hopper" (page 23).
3
Load the documents on the hopper with the front side
(scanning side) facing up.
Make sure not to place the documents all the way in.
4
Perform a scan from ScandAll PRO.
For information on how to perform scanning, refer to "How to Use
ScandAll PRO".
Contents
Introduction
"1.4 Opening/
Scanner
Overview
[10: Hopper Level]
How to Load
"4.2 Main Menu" (page
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
95