Function Selection; How To Use Function Selection - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 4 How to Use the Operator Panel

4.3 Function Selection

This section explains about the Function Selection.
When you press the [Function/Enter] button in the [Ready]
screen, [Function Selection] is displayed.
By using Function Selection, you can configure an application
to be launched when the [Send to/Pause] button is pressed.

How to Use Function Selection

Menu Function
/Enter
Send to Clear
Check
/Pause /Back
Stop [ ] / [ ] Button
[Function/Enter] Button
Scan
Counter
iMFF Reset Eject
Power Button
[Function/Enter] Button
1
Press the power button on the front of the scanner.
[Ready] is displayed on the LCD. The indicator displays [F01]
when the power has just been turned on.
2
Press the [Function/Enter] button.
[Function Selection] is displayed on the LCD.
3
Press the [ ] or [ ] button and select a parameter, then
press the [Function/Enter] button to confirm.
For more details about the setting parameters, refer to
Configurable in Function Selection" (page
The setup is completed when the LCD displays the [Ready]
screen.
The configured parameter is shown by the indicator.
In this example, the indicator displays "F02".
Note that No.C indicates that the setting is fixed at the Software
Operation Panel. If No.C is selected, the indicator displays "SOP".
Contents
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
"Item
Settings
82).
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
81