Table of Contents
Advertisement
Chapter 4 How to Use the Operator Panel
Items Configurable in the Main Menu
Item
1: iMFF Setting
When there is paper of the same size attached to a designated
location on the page, you can have the scanner memorize the
location of the attachment and not detect the same pattern as
multifeed.
Note that you need to specify [Detect by overlap (Ultrasonic)] in
either the scanner driver's setup dialog box or the multifeed
detection setting in
[Multifeed]" (page 207)
By selecting [4: Clear pattern], you can clear the overlapping
patterns (length, location) that were previously memorized in Auto
mode. It can also be configured from the Software Operation
Panel.
2: No. of Paper
Used to change the number of paper feeding retries (when the
Feed Retries
document is not picked properly).
It can also be configured from the Software Operation Panel.
3: Pick Speed
When you experience frequent multifeeds and paper jams, the
symptom may be improved by slowing down the speed in which
documents are picked (fed).
It can also be configured from the Software Operation Panel.
4: Soft Pick
When you experience pick errors from the separator roller slipping
Setting
on the paper, or paper jams from scanning thin papers of small
widths, the symptom may be improved by bringing down the pick
roller unit and keeping the unit at the lower position (disabling the
Soft Pick Setting).
It can also be configured from the Software Operation Panel.
Description
"Specifying a multifeed detection method
beforehand.
Setting/Value
- : No settings/values
1: Manual mode
2: Auto mode 1
3: Auto mode 2
4: Clear pattern
1 to 12 (times)
1: Normal
2: Slow
1: Disable
2: Enable
TOP
Contents
Index
Introduction
Factory Default
Scanner
Overview
1: Manual mode
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
3
Various Ways
to Scan
1: Normal
Daily Care
2: Enable
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
74
Advertisement
Table of Contents
Troubleshooting
