Scan Settings For Documents With; (Automatic Page Size Detection)] - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 9 Operational Settings
Scan Settings for Documents with Tabs/Non-
rectangular Documents
[Scan Setting for Document with Tab (Automatic
Page Size Detection)]
For documents with index stickers or index tabs attached on
the end, you can scan the whole document including its
attachments with Automatic Page Size Detection.
1
Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting 2]
[Scan Setting for Document with Tab (Automatic Page
Size Detection)].
3
Select one from [Document with tab], [Document without
tab] or [Non-rectangular document].
Item
Document with tab
Document without
tab
Non-rectangular
document
170).
The scanning speed slows down when you select
[Document with tab] or [Non-rectangular document].
To scan documents with tabs or non-rectangular
documents, refer to
Non-rectangular Documents" (page
For information on how to configure Automatic Page
Size Detection, refer to
Skewed Document Images" (page
When connected via SCSI or USB Connector 2, the
tab may be missing from the scanned image when a
document smaller than A5 size is scanned.
Description
Scans up to 20 mm off the bottom edge of
the document with a tab.
Stops the scan when it detects the bottom
edge of the document.
Scans up to 120 mm off the bottom edge of
the detected document.
(Not available when connected via SCSI or
USB Connector 2)
"Loading Documents with Tabs or
43).
"Automatically Correcting
97).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
203