Scanner Is Not Recognized By The Computer When Using Kofax Vrs - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 8 Troubleshooting
Scanner is not recognized by the computer when
using Kofax VRS.
Is the interface cable connected correctly?
Yes
Is it connected via SCSI/USB Connector 2?
Yes
Is the SCSI ID set to a number other than "9"?
Yes
Connect the interface cable correctly.
For information on how to connect the cables, refer to "Connecting Cables" in
No
"Getting Started".
Connect via SCSI or USB Connector 2.
No
Configure the SCSI ID to a number other than "9".
No
If the above countermeasures do not solve the problem, check the items in
Before You Contact the Scanner Service Provider" (page 166)
your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
"8.4 the Operator
first, then contact
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
165