Documents - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 6 Daily Care
Scan Glass
Clean it lightly.
Paper path upper-side (glasses: 2 sheets)
Glass (removable)
Glass (not removable)
The glass should not have to be removed as it is
designed to block paper dust. Remove and clean the
glass only if the scanner is being used in an environment
with large amounts of paper dust and vertical streaks
appear on the scanned image even after cleaning the
glass. Be careful not to let any paper dust in when
removing the glass. Clean the glass on paper path upper-
side as follows:
1
1 Loosen the screw until the glass can be lifted.
2 Tilt the glass to the angle as shown above.
3 Remove the glass as you slide it to the right.
3
2
4 Clean the removed glass.
5 From the gap where the glass was attached, clean
the other layer of glass inside, using a cotton swab
or something alike.
Cross-section
Vertical streaks may appear on the scanned image when
the glass is dirty.
TOP
Contents
Index
Introduction
Scanner
Glass
Overview
How to Load

Documents

Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
126