Konica Minolta Fujitsu fi-6800 Operating Manual page 76

Chapter 4 How to Use the Operator Panel
Item
7: MF Quick Enables you to switch whether or not to detect multifeed by a push
Change of a button. Priority is given to the driver setting when [1: Disable]
is selected.
When [2: Enable(Detect)] or [3: Enable(Ignore)] is selected, it
switches between detecting/not detecting multifeed every time the
[Eject] button is pressed. It can be switched during scanning.
For [2: Enable(Detect], it detects multifeed by default and
multifeed detection is performed according to the driver setting.
For [3: Enable(Ignore)], it does not detect multifeed by default and
this setting is given priority over the driver setting.
8: Alarm Volume Specify whether or not to ring an alarm when an error such as
multifeed or paper jam occur.
It can also be configured from the Software Operation Panel.
9: Stacker Adjust the stacker position.
Positioning You can set the stacker at certain heights.
10: Hopper Level Change the hopper level during standby. Selecting [1: Manual
(Continuous)] switches the scanner to Manual Feed mode
(Continuous Feed mode). The hopper level cannot be changed in
Manual Feed mode (Single Feed mode).
Remove all documents from the hopper when you configure this
item.
The hopper is set to [4: Lower] when you clear manual feeding
(continuous).
11: Paper When you experience frequent multifeeds, pick errors or paper
Separation jams, take measures by adjusting the force to separate the
Force papers.
Keep the default setting for normal use.
For more details, refer to
Force" (page
12: Alarm Sound Specify the duration to ring the alarm in when errors such as
Time multifeed and paper jam occur.
Description
"1.9 Adjusting the Paper Separation
26).
Setting/Value
- : No settings/values
1: Disable
2: Enable(Detect)
3: Enable(Ignore)
1: OFF
2: Low
3: High
1: Movable
2: Fixed
1: Manual (Continuous)
2: Upper
3: Middle
4: Lower
Low High
0.5, 1, 1.5, 2.0, 2.5 (seconds)
TOP
Contents
Factory Default
Index
Introduction
1: Disable
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
1: OFF
How to Use
the Operator
Panel
(*1)
Various Ways
(*2)
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
2.0
Appendix
Glossary
76