Konica Minolta Fujitsu fi-6800 Operating Manual page 72

Chapter 4 How to Use the Operator Panel
■Checking the information
Menu Function
/Enter
Send to Clear
Check
/Pause /Back
Stop
Scan
Counter
iMFF Reset Eject
[ ] / [ ] Button
Power Button
[Menu] Button
[ ] / [ ] Button
[Function/Enter] Button
1
Press the power button on the front of the scanner.
[Ready] is displayed on the LCD.
2
Press the [Menu] button.
[Main Menu] is displayed on the LCD.
3
Press the [ ] or [ ] button and select [Information], then
press the [Function/Enter] button to confirm.
[Information] is displayed on the LCD.
[Information] can be selected only when there is a
message for replacing consumables/cleaning/replacing
maintenance parts/regular maintenance.
4
Press the [ ] or [ ] button to check the contents of the
information.
You can check the messages for replacing consumables/cleaning/
replacing maintenance parts/regular maintenance.
When the message prompts replacing consumables/maintenance
parts or cleaning, the corresponding counter that requires
consumable replacement/maintenance part replacement/cleaning is
highlighted.
Counters will appear highlighted when:
The page count after replacing the consumable reaches 95% of the
value configured in "Specifying the Cycle to Replace Consumables
[Life Counter Alarm Setting]" (page 185)
Panel. (For brake roller/pick roller/separator roller counters)
The scanner determines that the condition of the roller has
exceeded the threshold that can be corrected, by monitoring the
wear on the roller. (For assist roller counter)
The page count after cleaning reaches 100% of the value
configured in "Specifying the Cycle to Clean the Scanner [Cleaning
Cycle]" (page 184) in the Software Operation Panel. (Cleaning
counter)
The amount of remaining ink reaches below 33%. This is only
displayed when the imprinter is installed. (For [Ink Level: Front] /
[Ink Level: Back]
Contents
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
in the Software Operation
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
72