Cleaning The Adf (With Cleaning Sheet); Documents; How To Use - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 6 Daily Care

6.2 Cleaning the ADF (with Cleaning Sheet)

Use the Cleaning Sheet to clean the rollers on both the upper
and lower sides of the paper path.
For more details about the Cleaning Sheet, refer to
Materials" (page 119).
Clean by following the instructions specified for the Cleaning
Sheet.
The glasses inside the ADF become very hot
when the scanner is being used.
When cleaning the inside of the scanner, make
sure to unplug the power cable and wait for at
least 15 minutes before you start cleaning.
■Cleaning with the Cleaning Sheet
1
Press the power button on the front of the scanner.
[Ready] is displayed on the LCD.
2
Press the [Menu] button.
[Main Menu] is displayed on the LCD.
3
Press the [ ] or [ ] button and select [21: Cleaning], then
press the [Function/Enter] button to confirm.
[Cleaning (Sheet)] is displayed on the LCD.
Do not perform scanning from the scanner driver during
cleaning.
4
Set the width of the hopper side guides to B4.
For information on how to set the hopper side guides, refer to
Loading Documents" (page 34).
5
Adjust the stacker extension to the length of the Cleaning
Sheet, and pull up the paper stop.
For information on how to set the stacker, refer to
"Cleaning
Setting" (page
6
Remove the protective paper off the Cleaning Sheet.
7
Place the Cleaning Sheet on the left-hand side between
the side guides with its adhesive side facing up.
Adhesive side
"2.1
"1.8 Stacker
24).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load

Documents

Configuring
the Scan
Settings

How to Use

the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
121