Table of Contents
Advertisement
Chapter 9 Operational Settings
Specifying an Area Not to Detect Multifeed
[Intelligent Multifeed Function]
When there is paper of the same size attached to a
designated location on the page, the scanner can memorize
the location of the attachment and can be configured not to
detect multifeeds for that location. To configure this setting,
you first need to select [Check Overlapping (Ultrasonic)] for
the multifeed detection setting in
detection method [Multifeed]" (page 207)
driver's setup dialog box.
1
Start up the Software Operation Panel.
Refer to
"9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, click [Device Setting 2]
[Intelligent Multifeed Function].
"Specifying a multifeed
or the scanner
170).
3
Select an operation mode and click the [OK] button.
Mode
Manual mode
Stops feeding the documents when a multifeed is
detected. You can resume scanning by loading the
documents back on the hopper. The size and
location of the paper attachment are not
memorized.
Auto mode 1
Memorizes the size and location of the paper
attachment upon resuming the scan when a
multifeed is detected and the document is loaded
back on the hopper. The memorized pattern is
ignored from the next scan.
Auto mode 2
Memorizes the size of the paper attachment upon
resuming the scan when a multifeed is detected
and the document is loaded back on the hopper.
The memorized pattern is ignored from the next
scan.
By selecting the [Clear overlap pattern] check box, you
can erase the overlapping patterns (length, position)
that were memorized in Auto mode.
You can specify whether to enable or disable the
[Scan] button when using Kofax VRS in [Enable Scan
button (VRS)].
By selecting the [Auto-Memorize MF Pattern (only
when MF images are displayed)] check box, you can
have the multifeed pattern memorized in the window
that shows the multifed images.
In [Remember multifeed pattern at power-off], you can
select whether or not to memorize the multifeed
pattern upon turning the power off. When [Remember]
is selected, you can use the memorized multifeed
pattern when the scanner is powered on next.
This setting can also be configured from the operator
panel.
For information about the procedure after this step, refer to
"Bypassing Multifeed Detection for a Fixed Format" (page
Description
114).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
213
Advertisement
Table of Contents
Troubleshooting
