Table of Contents
Advertisement
Chapter 2 How to Load Documents
2.1 Loading Documents
This section explains how to load documents on the scanner.
Preparation
Prepare the documents as described below.
For details about the paper size and paper quality required for
normal operations, refer to
(page
40).
1
Check the documents.
1 Check if the documents to be loaded are of the same size or
different sizes. Ways to load documents differ depending on
whether the documents are the same size or not.
2 Check the number of sheets. Up to 500 sheets can be loaded (with
2
paper weight of 80 g/m
[20 lb], thickness of the document stack
under 50 mm, and the total weight under 5 kg).
For more details, refer to
"Loading Capacity" (page
For documents with tabs or non-rectangular
documents, refer to
Non-rectangular Documents" (page
For documents with different widths, refer to
a Mixed Batch of Documents" (page 46)
"Scanning Documents of Different Widths" (page
"2.2 Documents for Scanning"
42).
"Loading Documents with Tabs or
43).
"Scanning
and
86).
2
Fan the documents.
1 Hold both ends of the documents and bend them.
2 Firmly holding the documents with both hands, bend them back in
the opposite direction as follows.
3 Repeat steps
1)
and
2)
a few times.
4 Rotate the documents by 90 degrees and fan them in the same
manner.
5 Align the edges of the documents.
For information on how to fan documents, refer to the
"Error Recovery Guide".
The Error Recovery Guide is included in the SETUP DISK
DVD-ROM. For information on how to install the Error
Recovery Guide, refer to "Installing the Scanner
Software" in "Getting Started".
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
34
Advertisement
Table of Contents
Troubleshooting
