Scanning Documents Of Different Widths - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 5 Various Ways to Scan

Scanning Documents of Different Widths

When you scan a batch of documents with different widths,
load the documents using the following procedure:
When you scan documents of different widths at the same
time, some of the smaller documents may be skewed or
may not be fed into the scanner. Try to scan documents of
the same width.
For more details about the conditions of scanning
documents in mixed batches, refer to
Batch of Documents" (page
1
To avoid skewed images, select [Automatic Page Size
Detection] in [Automatic Size and Skew Detection].
For more details about settings, refer to
Skewed Document Images" (page
2
Align the edges of the documents.
Align by the center
Align by the side
3
Place the documents on the hopper and adjust the hopper
side guides to the widest document in the batch.
"Scanning a Mixed
46).
"Automatically Correcting
97).
For information on how to load documents on the hopper, refer to
Loading Documents" (page 34).
Make sure that all documents are placed underneath the
pick roller, otherwise the document will not be picked.
Good example
Bad example
4
Perform a scan from ScandAll PRO.
For information on how to perform scanning, refer to "How to Use
ScandAll PRO".
Contents
"2.1
Index
Introduction
Scanner
Pick Roller
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Pick Roller
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
86