Konica Minolta Fujitsu fi-6800 Operating Manual page 116

Chapter 5 Various Ways to Scan
Operational procedure
1
After a multifeed error occurs, either press the [Eject]
button to eject the document from the paper path, or open
the ADF to remove the document.
When the document is removed, the display on the operator panel
LCD changes as follows:
Upon multifeed
Multifeed detected (Overlap)
Press the iMFF button to eject the document and
to suppress multifeed detection from next scans.
Press the Eject button just to eject the document.
When [Ready] is displayed, increase the paper
separation force by using the [ ] button to
suppress multifeeds. (*1)
Multifeed detected (Overlap)
Press the Eject button to eject the document.
When [Ready] is displayed, increase the paper
separation force by using the [ ] button to
suppress multifeeds. (*1)
Multifeed detected (Overlap)
Press the iMFF button to memorize the multifeed
pattern and eject the document. Press the Eject
button to eject the document.
When [Ready] is displayed, increase the paper
separation force by using the [ ] button to
suppress multifeeds. (*1)
Multifeed detected (Overlap)
Press the iMFF button to memorize the multifeed
pattern. Press the Eject button to eject the
document.
When [Ready] is displayed, increase the paper
separation force by using the [ ] button to
suppress multifeeds. (*1)
Multifeed detected (Length)
Press the Eject button to eject the document.
*1: When the paper separation force is set to [
maximum level, the part of the message "When [Ready] is displayed,
increase the paper separation force by using the [ ] button to suppress
multifeeds." does not appear.
2
Place the removed document back on the hopper.
If a multifeed error is detected while no paper is attached on the
document, press the [Scan] button or restart scanning via the
Upon ejecting
computer (do not press the [iMFF] button). If there is a paper
document
attachment on the ejected sheet and the attachment is likely to be the
cause of the multifeed error, then proceed to the next step.
[Ready
(Multifeed)]
screen
Menu
Send to
/Pause
Counter
iMFF
If you click the [OK] button in the window that shows the
multifeed image, step
feeds the multifeed image and continues the scan.
[Ready] screen
LCD
Function
/Enter
Clear
Check
/Back
Stop
Scan
[Scan] Button
Reset Eject
[Eject] Button
[iMFF] Button
2 is not required because the scanner
TOP
Contents
] which is the
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
116