Parts And Functions; Front - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 1 Scanner Overview

1.2 Parts and Functions

This section shows the names of the scanner parts.

Front

Stacker
Stacks up the ejected documents. It
can be kept at an optimum height to
straighten the documents.
Stacker Side Guide
Aligns the documents in width direction
as they are ejected onto the stacker.
Stacker Extension
Pull out and adjust to the length of the
documents.
Paper Stop
Guides the ejected documents in length
direction to prevent them from being
scattered. Though documents can be
aligned without the paper stop, use it to
stack them more neatly.
Hopper Side Guide
Guides the documents in width direction
as they are fed into the scanner.
Hopper Extension
Pull out to place long documents on
the hopper.
Hopper
A table for loading documents to scan.
ADF (Automatic Document
Feeder)
Pulls and feeds the documents loaded on
the hopper one at a time.
Open it to replace the consumables or
Paper Output
Ejects the scanned documents.
Top Cover
A cover for the upper paper path.
Open it to remove jammed
documents or clean the inside of the
scanner.
Top Cover Release Tab
Lift up to open the top cover.
Operator Panel
Consists of LCD, buttons and LED.
It can be used to operate the
scanner or check its status.
For details about the operator panel,
refer to "Chapter 4 How to Use the
Operator Panel" (page 60).
Power Button
Press to turn the power ON/OFF.
ADF Release Tab
Lift up to open the ADF.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
14