Replacing The Pick Roller; Daily Care - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 7 Replacing Consumables

7.2 Replacing the Pick Roller

There are two pick rollers. Make sure to replace both two units.
1
Remove all documents from the stacker.
2
Open the ADF.
For information on how to open the ADF, refer to
Closing the ADF" (page 20).
Be careful not to have your fingers caught
when the ADF closes.
3
Remove the pick rollers (×2) from the scanner.
1 Open the roller cover. Grab the tabs on the left and right side with
your fingers and pull down the cover towards you.
Tab
2 Pull the pick roller off the rotating shaft as you grab the tab on the
pick roller (×2).
"1.5 Opening/
4
Install a new set of pick rollers (×2) in the scanner.
1 Place the pick rollers (×2) on the shaft.
2 Close the roller cover. Make sure that both ends of the cover are
Roller Cover
locked firmly.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
Pick Roller
the Operator
Panel
Various Ways
to Scan

Daily Care

Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
132