Konica Minolta Fujitsu fi-6800 Operating Manual page 94

Chapter 5 Various Ways to Scan
■ Scanning in Single Feed mode
1
Lift up the pick roller unit.
Push up the tab in the middle with your finger.
The pick roller unit will click into place.
The hopper moves up to the feeding position.
Make sure that there is no document left on the
hopper.
Be careful not to have your fingers or anything caught
when the hopper moves up.
Pick Roller Unit
2
Load a document on the hopper with the front side
(scanning side) facing up.
Make sure not to place the document all the way in.
3
Perform a scan from ScandAll PRO.
For information on how to perform scanning, refer to "How to Use
ScandAll PRO".
4
Insert the document until the top edge touches the rollers
on the inside.
The document is picked, scanned, then ejected onto the stacker.
After the scan, the scanner waits for the next sheet to be fed for
the time specified in the Software Operation Panel.
Let go of the document as soon as you confirm that the
document is being fed by the rollers.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
Roller
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
94