Konica Minolta Fujitsu fi-6800 Operating Manual page 175

Chapter 9 Operational Settings
Item Description
Pre-Pick Select [Yes] to prioritize the
processing speed and [No] for
otherwise.
It can also be configured from the
scanner driver's setup dialog box.
Note that priority is given to the
scanner driver setting.
Page Edge Filler Specify the range of area to fill in
(Automatic Page when [Automatic Page Size
Size Detection) Detection] is selected.
Specify a width for the margin off the
edge of the scanned image to fill in
black or white.
It can also be configured from the
scanner driver's setup dialog box.
Note that priority is given to the
setting with a larger value.
Document check Selected range: Select this item to
area specification restrict the area to run multifeed
for Multifeed detection on.
Detection
Enable/Disable (Left/Middle/Right):
Specify whether to enable or disable
multifeed detection for the specified
area.
Start: Specify the start point of the
check area in length (mm) from the
top edge of the document.
End: Specify the end point of the
check area in length (mm) from the
top edge of the document.
Setting/Value
Yes / No
Top/Bottom/Left /Right: 0 to 7.5 mm (in
increments of 0.5 mm)
(A: Image, B: Filled area, A+B: Output)
[Selected range] check box
Enable / Disable
(when [Selected range] is selected)
0 to 510 mm
(in increments of 2 mm)
0 to 510 mm
(in increments of 2 mm)
Factory Default SCSI or USB
Connector 1
: Configurable
-: Not configurable
Yes
Top/Bottom/Left/
Right: 0 mm
Not selected
Disable
0 mm
0 mm
TOP
Contents
SCSI or USB
Index
Connector 2
Introduction
Scanner
Overview
-
How to Load
Documents
Configuring
the Scan
-
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
175