Chapter 9 Operational Settings
9.4 Settings Related to Scanning
Adjusting the Starting Position for Scanning
[Offset/Vertical Magnification Adjustment]
When the output position of the scanned image is not correct
or the image appears shortened/elongated (vertically), use the
following procedure to adjust the offset and the vertical
magnification for correction.
Normally, you should not have to make any adjustments as the
factory default settings are configured at appropriate values.
1
Start up the Software Operation Panel.
Refer to
"9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting] and
click the [Offset] button.
170).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
186