Chapter 9 Operational Settings
Settings for Multifeed Detection in Manual
Feeding
[Multifeed detection when scanning in manual
feeding mode]
Configure this setting when you want to enable multifeed
detection for scanning in Manual Feed mode.
1
Start up the Software Operation Panel.
Refer to
"9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting 2]
[Multifeed detection when scanning in manual feeding
mode].
3
Select a detection method.
Detection
Disable
Follow driver
settings
170).
Description
Does not detect multifeeds.
Detects multifeeds if multifeed detection is
enabled in the scanner driver settings.
(Displays [Follow multifeed settings] when
connected via SCSI or USB Connector 2.)
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
209