Setting For A Function To Save The Documents From Being Damaged [Paper Protection] - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 9 Operational Settings
Setting for a Function to Save the Documents
from Being Damaged [Paper Protection]
Specify whether to enable or disable Paper Protection.
Feeding errors during scanning could damage or tear valuable
documents. Enabling this setting reduces the risk of having
your documents damaged in such ways, by stopping the scan
when the scanner detects a document that is unusually
warped.
This function can be used to scan documents such as thin
papers which are difficult to feed.
1
Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting 2]
[Paper Protection].
3
Specify whether to enable or disable Paper Protection.
When you select [Enable], the scanner stops the scan when it detects
a document that is unusually warped.
Note that Paper Protection is a function that
suppresses the documents from being damaged, and
does not guarantee all documents to be saved.
When you enable Paper Protection, make sure to set
the documents with their top edges aligned (especially
for a mixed batch with different lengths).
If the top edges are not aligned properly, the Paper
Protection function may be activated and stop the
scan even when the documents are being fed
correctly.
Paper Protection is disabled in Manual Feed mode.
170).
This setting can also be configured from the scanner
driver's setup dialog box or the operator panel. Note
that priority is given to the scanner driver setting
unless you have prioritized the operator panel setting.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
201