Imprinter Settings [Imprinter Selection] - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 9 Operational Settings

Imprinter Settings [Imprinter selection]

Specify which imprinter to use when both Front-Side Imprinter
and Back-Side Imprinter are installed.
This setting does not appear when no imprinter is installed.
1
Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, click [Device Setting 2]
[Imprinter selection].
3
Select the Imprinter to use.
Normal
(obey Host specification):
Forcibly select Front-Side
Imprinter:
Forcibly select Back-Side
Imprinter:
170).
For information about the Imprinter, refer to
Scanner Options" (page
This setting can also be configured from the scanner
driver's setup dialog box. Note that priority is given to
the scanner driver setting.
Follows the scanner driver setting.
Forces the Front-Side Imprinter to be
used unless specified otherwise by
the scanner driver.
Forces the Back-Side Imprinter to be
used unless specified otherwise by
the scanner driver.
"A.4
225).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
218