Error Indications On Operator Panel - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 8 Troubleshooting

8.2 Error Indications on Operator Panel

When an error occurs, the Check LED lights in orange. Error
codes displayed on the LCD begin with the letter "J" or "U" for
temporary errors and "E", "F", "C", "H", "A" or "L" for device
errors. Temporary errors can be recovered by the operator,
whereas device errors require a service engineer to recover
from. You can clear the error display by pressing the [Clear/
Back] or the [Stop] button. Note that if the error is "Paper jam",
the message disappears after a certain amount of time
elapses with no documents ([Ready] status) in the scanner.
LCD
Menu Function
[Clear/Back] Button
/Enter
Send to Clear Check LED
Check
/Pause /Back
Stop
[Stop] Button
Scan
Counter
iMFF Reset Eject
If the Error Recovery Guide is installed in your computer, the
Error Recovery Guide window appears when the Windows
operating system is started up. When an error or a malfunction
occurs, the Error Recovery Guide window displays related
information such as the name of the error and the error code
(number).
Write down the information shown in the window and click the
[More Info] button to check for troubleshooting methods.
When you scan a lot of documents written with lead pencil, the
following message may appear:
"Clean the consumables (brake roller, separator roller and pick
roller) because they may be dirty. Also try pressing the
button to lower the paper separation force when [Ready] is
displayed. If this message keeps on appearing, replace the
consumables. Refer to the manual for information on how to
clean or replace the consumables."
This message only appears on the operator panel without an
error code.
Troubleshoot as instructed in the message.
For information on how to clean the consumables, refer to
"Chapter 6 Daily Care" (page
For information on how to adjust the paper separation force,
refer to "1.9 Adjusting the Paper Separation Force" (page
For information on how to replace the consumables, refer to
"Chapter 7 Replacing Consumables" (page
Error Recovery Guide is included in the SETUP DISK DVD-
ROM.
For information on how to install the Error Recovery Guide,
refer to "Installing the Scanner Software" in "Getting Started".
118).
26).
130).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
142