Konica Minolta Fujitsu fi-6800 Operating Manual page 187

Chapter 9 Operational Settings
3
Adjust the offset/vertical magnification as necessary.
Offset Setting
Unit Select [ADF (front)] or [ADF (back)] as the target
for offset adjustment.
Note that when the connection is via SCSI or
USB Connector 2, you can only adjust the offset
for [ADF (back)].
Main Adjusts the horizontal (width) offset.
The setting range is from -2 to 3 mm in 0.5 mm
increments.
Sub Adjusts the vertical (length) offset.
The setting range is from -2 to 3 mm in 0.5 mm
increments.
Description
Vertical magnification
Adjustment
Unit The target for vertical
magnification adjustment is fixed
at [ADF].
Vertical magnification Adjusts the vertical (length)
Adjustment (length) magnification.
The setting range is from -3.1 to
3.1% in 0.1% increments.
Contents
Description
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
187