Images Are Distorted Or Not Clear - Konica Minolta Fujitsu fi-6800 Operating Manual

Chapter 8 Troubleshooting

Images are distorted or not clear.

Are the glasses and rollers inside the ADF clean?
Yes
Is the top of the ADF being pushed down during scanning?
Is there a heavy object placed on top of the ADF?
No
Is anything causing the scanner to vibrate during
scanning?
No
Is the scanner placed on a flat and level surface? Also, are
there rubber pads attached on the bottom of the scanner?
Yes
Clean the dirty locations.
For information on how to clean the dirty locations, refer to
No
(page 118).
Do not press down on the top of the ADF or place any heavy objects on the ADF
during scanning.
Yes
Do not allow the scanner to vibrate during scanning.
Yes
Either place the scanner on a flat and level surface, or attach the rubber pads on
the bottom of the scanner.
No
If the above countermeasures do not solve the problem, check the items in
Before You Contact the Scanner Service Provider" (page 166)
your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.
TOP
Contents
Index
Introduction
"Chapter 6 Daily Care"
Scanner
Overview
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
"8.4
to Scan
first, then contact
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
157