Installing A Tape Drive; Figure 72. Removing The Slimline Optical Drive From The Server System - Intel SR2625UR - Server System - 0 MB RAM Service Manual

Figure 72. Removing the Slimline Optical Drive from the Server System

2. Slide the optical drive out (see letter "B" in
3. If no device will be installed in this location, install a filler blank in this location.

Installing a Tape Drive

To install a tape drive into Intel
must meet the following requirements:
•
You must purchase either the SATA or SCSI tape drive kit, order number
ASR2500SATAPE or ADRTAPEKIT.
•
You must purchase a 3.5-inch tape drive.
•
Your server system must have a free SATA port on the server board or you must
have an add-in card that supports a tape drive.
After purchasing the tape drive kit and the tape drive, use the following instructions to
install the tape drive. In addition to these instructions, refer to the instructions that came
with your tape drive for additional requirements.
1. Remove the drive tray from the server system by pressing the blue release lever
(see letter "A" in
out from the front of the system (see letter "B" in
84
B
®
Server System SR2600UR/SR2625UR, your system
Figure 73) and pushing it forward to release it and then sliding it
®
Intel Server System SR2600UR/SR2625UR Service Guide
Figure 72)
Figure 73).
A
AF002991