Table of Contents
Advertisement
Installing a Tape Drive
To install a tape drive into your Server Chassis SR2400/SR2400DC, your system must meet the
following requirements:
⎯ You must purchase the tape drive kit, order number ADRTAPEKIT.
⎯ You must purchase a 3.5-inch SCSI tape drive.
⎯ You must have either the SATA or SCSI backplane installed.
After purchasing the tape drive kit and the tape drive, use the instructions below to install them. In
addition to these instructions, refer to the instructions that came with your tape drive for additional
requirements.
1. Observe the safety and ESD precautions at the beginning of this book. See
Information."
2. Power down the server and unplug all peripheral devices and the AC power cable or DC
external source.
3. Remove the chassis cover. For instructions, see
4. Remove the front bezel. For instructions, see
5. Push the tape drive filler panel from the chassis by using a long screwdriver to push it out from
the inside of the chassis. See the figure below to locate the tape drive filler panel.
90
Figure 80. Removing the Tape Drive Bay Filler Panel
"Removing the Chassis Cover."
"Removing the Front Bezel."
"Safety
TP01355
Advertisement
Table of Contents
