Installing And Removing The Raid Battery Backup Unit (Active Systems Only); Installing The Raid Battery Backup Unit (Bbu) - Intel SR2625UR - Server System - 0 MB RAM Service Manual

8. Install the PCI riser assembly. For instructions, see
Assembly" on page
Installing and Removing the RAID Battery Backup Unit
(Active Systems Only)

Installing the RAID Battery Backup Unit (BBU)

To install the RAID battery backup unit, follow these steps:
1. Remove the PCI riser assembly. For instructions, see
Assembly" on page
2. Remove the processor air duct. For instructions, see
Duct" on page
3. Remove the large air baffle. For instructions, see
on page
4. Open the RAID battery backup unit cover (see letter "A" in
connect the cable as shown (see letter "B" in
5. Close and latch the battery backup unit cover.
6. Insert the RAID battery backup unit into the server system making sure the hooks
on the underside of the RAID BBU aligns with the matching chassis tabs and slide
towards the power supply until it locks into place (see letter "C" in
7. Connect the cable from the rear of the RAID battery backup unit to the midplane
board (see letter "D" in
®
Intel Server System SR2600UR/SR2625UR Service Guide
51.
50.
56.
70.
Figure
"Installing the PCI Riser
"Removing the PCI Riser
"Removing the Processor Air
"Removing the Large Air Baffle"
Figure 107).
107).
Figure 107) and
Figure 107).
113