Table of Contents
Advertisement
Note: Do not skip step 2. You will need these settings to configure your server at the end of the
procedure.
Obtaining the Upgrade
Download the BIOS image file to a temporary folder on your hard drive. See
Information and Software" on page 4
Note: Review the instructions and release notes that are provided in the readme file distributed
with the BIOS image file before attempting a BIOS upgrade. The release notes contain
critical information regarding jumper settings, specific fixes, or other information to
complete the upgrade.
Upgrading the BIOS
Follow the instructions in the readme file that came with the BIOS upgrade. When the
update completes, remove the bootable media from which you performed the upgrade.
Caution: Do not power down the system during the BIOS update process! The system will reset
automatically when the BIOS update process is completed.
Note: You may encounter a CMOS Checksum error or other problem after reboot. If this
happens, shut down the system and boot it again. CMOS checksum errors require that you
enter Setup, load BIOS defaults, check your settings, save your settings, and exit Setup.
Clearing the Password
If the user or administrator password(s) is lost or forgotten, moving the password clear
jumper into the "clear" position clears both passwords. The password clear jumper must
be restored to its original position before a new password(s) can be set.
1. Power down the system. Do not unplug the power cord.
2. Open the server system. For instructions on removing the system cover, see
"Removing the System Cover" on page
3. Locate the Password Clear jumper block at board position J1E8.
4. Move the jumper from the normal operation position, that is, Password Clear
Protect position (covering pins 1 and 2) to the Password Clear Erase position
(covering pins 2 and 3).
142
for a web link to the update software.
48.
®
Intel
Server System SR2600UR/SR2625UR Service Guide
"Additional
Advertisement
Table of Contents
