9. If no device will be installed in this location, install a filler blank as shown in
Figure
10. Install the server system cover. For instructions, see
Cover".
11. (Optional) Install the front bezel. For instructions, see
12. Plug all peripheral devices and the AC power cable(s) into the server.
Installing a Tape Drive
To install a tape drive into your server system, your system must meet the following
requirements:
•
You must purchase the tape drive kit, order number ADRTAPEKIT.
•
You must purchase a 3.5-inch tape drive.
•
You must have an add-in card that supports a tape drive.
After purchasing the tape drive kit and the tape drive, use the instructions below to install
them. In addition to these instructions, refer to the instructions that came with your tape
drive for additional requirements.
1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the front bezel if it is installed. For instructions, see
Bezel".
Intel® Server System SR2500AL User's Guide
42.
A
Figure 42. Installing Filler Blank into the Server System
AF000155
"Installing the Server System
"Installing the Front
"Removing the Front
Bezel".
"Safety
51