Virtualbaudrate; Basic 3G/4G Modem Configuration Commands; Autodeploy Sms Enable - HP MSR series Command Reference Manual

virtualbaudrate

Use virtualbaudrate to set a virtual baud rate for the DTE-side interface.
Use undo virtualbaudrate to remove the specified virtual baud rate.
Syntax
virtualbaudrate virtualbaudrate
undo virtualbaudrate
Views
Synchronous serial interface view
Default command level
2: System level
Parameters
virtualbaudrate: Baud rate (in bps) to be set, which must be consistent with the one configured at the DCE
side. It can be 1200, 2400, 4800, 9600, 19200, 38400, 56000, 57600, 64000, 72000, 1 15200,
128000, 192000, 256000, 384000, 512000, 768000, 1024000, 2048000, or 4096000.
Usage guidelines
When operating as DTE, the serial interface determines its baud rate through negotiation with the DCE
side. The virtualbaudrate command, however, allows you to configure DTE-side baudrate manually, but
the configured value must be the same as the one set at the DCE side.
If the clock selection mode of the serial interface is dteclk5, the virtual baud rate you configure here is the
line rate.
Configure the baudrate command at DCE side and the virtualbaudrate command at DTE side (only
when the interface is operating in synchronous mode). Avoid configuring the two commands at the same
end of a link.
At DCE side, the display interface command displays the baud rate of the interface; whereas at the DTE
end, the command displays the virtual baud rate of the interface.
Examples
# Set the virtual baudrate of DTE interface Serial 2/0 to 19200 bps.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] virtualbaudrate 19200
Related commands
baudrate
•
clock
•

Basic 3G/4G modem configuration commands

autodeploy sms enable

Use autodeploy sms enable to enable the SMS method of deploying configuration on the device.
Use undo autodeploy sms enable to disable SMS method of deploying configuration on the device.
76