Adding A Second 3.5-Inch Hard Disk Drive - HP 6000 SERIES Hardware Installation Manual

HP Series 6000 Hardware Installation Manual
Adding a Second 3.5-inch Hard Disk Drive
Note
Only the front slots can contain two 3.5-inch hard disk drives.
Since the rear slot (slot 2) has only one SCSI connector, only one
device can be installed in this slot.
If
you are adding a second 3.5-inch hard disk drive into an existing bracket, first
remove the existing hard disk drive and bracket as follows:
1. Disconnect the dc power cable.
2. Disconnect the address cable from the drive.
3. Disconnect the SCSI cable.
4. Remove the T25 bracket screw from the chassis front panel, then remove the
drive and bracket from the mass storage system.
N ow add the new drive to the existing bracket:
1.
Remove the TI0 bracket screws from the new drive and bracket you
received in the new upgrade kit.
2. Remove the new drive from the mounting bracket.
3. Remove th RFI baffle from the mounting bracket.
4. Install the new drive into the open slot of the mounting bracket.
5. Secure the drive in the mounting bracket with the TI0 bracket screws (see
Figure 3-3).
If
you are installing two drives at the same time (from two upgrade kits),
perform the following steps:
1. Remove the TIO bracket screws from one of the drives, and remove the drive
from the mounting bracket.
2. Remove th RFI baffle from the mounting bracket.
3. Install the drive that was just removed into the open slot of the mounting
bracket you received in the other upgrade kit.
4. Secure the drive in the mounting bracket with the TI0 bracket screws (see
Figure 3-3).
3.5·inch Hard Disk Drive Installation 3·5