Specify the LDAP server authentication method.
When Using the Dell™ Printer Configuration Web Tool
1. Launch Dell Printer Configuration Web Tool.
a. Open the web browser.
b. Enter the IP address of your printer in the web browser.
"Dell Printer Configuration Web
2. Select Print Server Settings.
3. Click the Security tab.
4. Select LDAP Authentication.
Confirm the authentication method.
When adding a text string to the UserID, specify Enable for Use Added Text String.
When specifying Enable for Use Added Text String, enter the additional text string in Text String Added
to User Name.
5. Click the Apply New settings button, and then turn off the printer to apply the settings.
Displays the current LDAP authentication method. Direct Authentication executes server authentication with the UserID
and password entered.
Use Added Text String
Specify whether to add a text string to the UserID. The change becomes effective after the printer is turned off and then
Text String Added to User Name
When using an added string for the user name, specify the text string to be added.
For example: if the user name is "email@example.com", normally you must enter "firstname.lastname@example.org".
However if Use Added Text String is set to Enable, and "@myhost.example.com" is specified in Text String Added to
User Name, only the data "abcde" must be entered with the printer driver, thus simplifying the entry task.
The change becomes effective after the printer is turned off and then on again.
Setting the Printer Driver
To print using ColorTrack, set the printer driver. Once set, the settings of the printer driver are enabled until they are
1. Open the Properties of the printer driver.
2. Configure the following settings from the Configuration tab.