If the printer is active on the network, you will receive a reply.
Using the Reset Button
Your printer is supplied with an electric leakage detector, which prevents electric shock or fire due to electric leakage by
automatically cutting circuits inside the printer.
When electric leakage is detected, the RESET button is tripped. In this case, press the RESET button to turn the printer
back on. If the RESET button trips again after pressing the RESET button, contact Dell.
Check whether or not the electric leakage detector is functioning at least once a month by following the steps below:
1. Turn on the printer, and then press the TEST button.
If the RESET button is tripped and the printer is turned off, the electric leakage detector functions correctly.
Press the RESET button to turn the printer back on.
If the RESET button is not tripped, contact Dell. Do not continue to use the printer if the electric leakage
detector is not functioning.
Back to Contents Page