Stand straight in front of the right hand cover and not in front of the front cover, whenever you replace the
3. Grasp both handles of the installed fuser with your hands and pull it out.
Installing a Fuser
1. Unpack a new fuser.
2. Grasp both handles of the fuser with your hands and install the fuser in the printer.
3. Close the right hand cover.
When closing the right hand cover, apply your hand in the vicinity of the handle as shown in the illustration,
and then press the cover firmly toward the printer.
Stand straight in front of the right hand cover and not in front of the front cover, whenever you close the
right hand cover.
Replacing the Separator Rollers
There are three separator rollers in the printer which need to be replaced periodically. One is in the tray and the others
are inside the printer. All the separator rollers are replaced in the same way as described in this section.