For encryption, AES or TKIP method is used.
This item is available only when the Infrastructure mode is selected for Network Type.
For authentication and encryption by digital certificate, AES or TKIP method is used.
This item is displayed only when the optional hard disk is installed and is set to On for encryption.
To activate the setting, import a certificate which supports wireless LAN (server) on the SSL/TLS pages, and enable
the relevant certificate in advance.
This item is available only when connecting the printer with a wireless network.
The optional wireless adapter supports WEP, WPA-PSK-TKIP, WPA-PSK-AES, and WPA-PSK-AES.
Reset Print Server
To initialize non-volatile RAM (NVRAM) for the network feature and reboot the printer. You can also initialize the printer's
NVRAM from Reset Defaults in the Printer Settings menu.
Initialize NIC NVRAM Memory
and restart printer
The Security tab includes Set Password, Authentication System, Kerberos Server, LDAP Server, LDAP
Authentication, SSL/TLS, IPsec, 802.1x and IP Filter(IPv4).
To set or change the password that is required to access the printer's setup parameters from the Dell Printer
Configuration Web Tool.
Set the password of the operator panel from Panel Lock in the Printer Settings. This page can also be displayed by
clicking Set Password in the Left Frame.
To restore the password to the default (NULL), initialize the non-volatile memory (NVM).
Access denial by the
failure of the
Click the Start button to initialize NVRAM. Network settings will revert to the factory
default settings and reboot the network capability.
Click the Start button to reboot the printer.
Sets the password using up to 10 alphanumeric characters. The password will appear as
asterisks (*) in the field when it is entered.
Enter the password again to confirm.
Specifies the amount of time the administrator should wait for the access to the printer's setup
from Dell Printer Configuration Web Tool. Sets the time period from 5 up to 255 seconds. The
access is denied if the time-out time is exceeded. If you set 0, this mode is disabled.