Copy Printer Settings - Dell 5130 Color Laser User Manual

Remote peers IPv6
address
Non IPsec
communication
policy
1
* This item is effective only when the optional hard disk is installed and is set to On for encryption.
NOTE: If IPsec is enabled with incorrect settings, you must disable it using the Reset IPsec menu on the operator
panel.
802.1x
Purpose:
To specify the settings for IEEE 802.1x authentication for encrypted communication to the printer.
Values:
Enable IEEE 802.1x
Authentication Method
Login Name: (Device
Name)
Password
Re-enter Password
IP Filter
Purpose:
To specify the IP address and subnet mask to be permitted or denied access to the printer.
Values:
Specifies the IP addresses that are permitted or denied access to the printer. Enter a numeric value
Address
between 0 and 255 in each field.
Address Specifies the subnet mask that are permitted or denied access to the printer. Enter a numeric value
Mask between 0 and 255 in each field.
Reject
Active
Permit
Mode
Disabled

Copy Printer Settings

The Copy Printer Settings menu includes the Copy Printer Settings and Copy Printer Settings Report pages.
Copy Printer Settings
Purpose:
To copy the printer settings and ColorTrack (Internal Setting) to one or more of the same model of the printer.
Specifies the IP address to connect to.
Selects whether or not to communicate with a device which does not support IPsec.
Select the check box to enable IEEE 802.1x authentication.
EAP-MD5
EAP-MS-CHAPv2
PEAP/MS-
CHAPv2
Specifies the login name (device name) for IEEE 802.1x authentication using up to 128
alphanumeric characters.
Specifies the login password for IEEE 802.1x authentication using up to 128 alphanumeric
characters.
Enter the login password again to confirm it.
Rejects printing from specified network address.
Permits printing from specified network address.
Disables the IP Filter feature for the specified IP address.
Select the authentication method to use for IEEE 802.1x authentication.