Dell 5130 Color Laser User Manual page 136

Certificate
3
Details*
1
* This item is available only when the self-signed certificate has been generated.
2
* This item is displayed only when the optional hard disk is installed and is set to On for encryption.
3
* This item is effective only when connected via SSL/TLS (https). Only the administrator is allowed to display the
pages.
4
* This item is displayed only when the optional hard disk is installed and is set to On for encryption. If not, "Certificate
Details" is displayed.
IPsec
Purpose:
To specify the Security Architecture settings for Internet Protocol (IPsec) for encrypted communication to the printer.
Values:
Protocol
IKE
1
Pre-Shared Key*
Re-enter Pre-Shared
Key
1
Device Certificate*
IKE SA Lifetime
IPsec SA Lifetime
DH Group
PFS
Remote peers IPv4
address
Displays the device to certificate selected at Certificate Management page
Category
or SSL/TLS page.
Issued To Displays the device to certificate.
Issuer Displays the issuer to certificate.
Serial Number Displays the serial number of the device.
Size of Public
Display Size of Public Key.
Key
Valid From Displays the time the certificate is valid.
Valid Until Displays the time the certificate is invalid.
Status Displays whether certificate is valid or not.
Certificate
Displays the purpose of certificate.
Purpose
Certificate
Selection Displays the type of device certificate you selected.
Status
E-mail Address Displayed only when an e-mail address is specified in the certificate.
Use This
Click to apply this certificate to the device.
2
Certificate*
Delete Click to delete this certificate.
Export This
Click to export the certificate to the other device.
2
Certificate*
Select the check box to enable the protocol.
Select IKE authentication. Digital Signature is displayed on the list only when an effective digital
signature is set up.
Specifies a shared key when Pre-Shared Key is selected for the IKE setting. Up to 255
alphanumeric characters, periods, and hyphens can be used.
Enter the shared key again to confirm it.
Displays the device certificate.
Sets the lifetime for IKE SA from 5 to 28,800 minutes.
Sets the lifetime for IPsec SA from 5 to 2,880 minutes.
Selects the DH group.
Selects the check box to enable the PFS setting.
Specifies the IP address to connect to.