Dell 5130 Color Laser User Manual page 176

Manual
Setup
Ad-hoc
Push
Button
Control
WPS
PIN Code
NOTE: This item is available only when connecting the printer with a wireless network.
Reset Wireless
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all wireless network settings
are reset to their default values.
NOTE: This item is available only when connecting the printer with a wireless network.
TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on again.
Values:
Dual Stack*
IP
IPv4 Mode
Mode
IPv6 Mode
Get IP
Address
IPv4
IP Address
Subnet Mask
Gateway Address
1
IPsec*
1
* Only displayed when an optional network protocol adapter is installed and IPsec is enabled.
Select to configure the wireless setting without the access point such as a wireless router.
No Select to configure the wireless setting without specifying the security method
Security from WEP.
Specify the WEP 64bit Key to use through the wireless network. Up to 10
WEP Key
hexadecimal characters can be entered.
Entry
Transmit
(64Bit)
Key
Specify the WEP 128bit Key to use through the wireless network. Up to 26
WEP Key
hexadecimal characters can be entered.
Entry
Transmit
(128Bit)
Key
Cancel*
PBC Start
Start
Start
Configures the wireless setting using the PIN code assigned automatically by the
Configu-
printer.
ration
Print PIN Prints PIN Code. Confirm it when entering PIN assigned to the printer into your
Code computer.
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Uses IPv6 to set the IP address.
AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enables the IP address entered on the operator panel.
Sets the IP address allocated to the printer by using the keys on the operator
panel.
Sets the subnet mask.
Sets the gateway address.
Disables IPsec.
Specify the transmit key from WEP Key 1, WEP Key 2, WEP Key
3, and WEP Key 4.
Specify the transmit key from WEP Key 1, WEP Key 2, WEP Key
3, and WEP Key 4.
Disables the security method of WPS-PBC.
Configures the wireless setting with the security method of WPS-PBC.