Enabling Cfs Over Ipv6 - Cisco Nexus 5000 Series Configuration Manual

Using Cisco Fabric Services
Procedure
Step 1
Step 2
Step 3

Enabling CFS over IPv6

You can enable or disable CFS over IPv6.
CFS cannot distribute over both IPv4 and IPv6 from the same switch.
Note
Procedure
Step 1
Step 2
Step 3
Verifying the CFS Over IP Configuration
The following example show how to verify the CFS over IP configuration, use the show cfs status command.
switch# show cfs status
Distribution : Enabled
Distribution over IP : Enabled - mode IPv4
IPv4 multicast address : 239.255.70.83
IPv6 multicast address : ff15::efff:4653
Command or Action
switch# configure
switch(config)# cfs ipv4 distribute
switch(config)# no cfs ipv4 distribute
Command or Action
switch# configure
switch(config)# cfs ipv6 distribute
switch(config)# no cfs ipv6 distribute
Cisco Nexus 5000 Series NX-OS System Management Configuration Guide, Release 5.2(1)N1(1)
Enabling CFS over IPv6
Purpose
Enters configuration mode.
Globally enables CFS over IPv4 for all
applications on the switch.
(Optional)
Disables (default) CFS over IPv4 on the switch.
Purpose
Enters configuration mode.
Globally enables CFS over IPv6 for all
applications on the switch.
(Optional)
Disables (default) CFS over IPv6 on the switch.
53