Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 73

authinit [<slotnumber>/]<portnumber>, [<slotnumber>/<portnumber>...| allE>]
slotnumber
portnumber
allE
Without any specified operands, the command displays the usage.
Examples To display authentication configuration on the switch:
To set DH-CHAP as the authentication protocol:
To set both protocols in order of FCAP and then DH-CHAP:
To set DH group 3:
To set all DH groups to be specified in auth negotiate in order of 0, 1, 2, 3, and 4:
To restart authentication for a director based switch, use the slot and port format for specifying the
port number:
See Also portShow, secAuthSecret
Fabric OS Command Reference Manual
53-1000436-01
Restarts authentication after changing the DH-chap group, hash type, and
shared secret between a pair of switches. This CLI works independent of the
authentication policy, that means you can initiate the authentication even if
the switch is in OFF or Auto Passive mode. This CLI requests for confirmation
and prints a general disclaimer/ warning message that the usage will be
disastrous and may bring down the E-port if the DH chap shared secrets are
not installed properly. Authentication proceeds only if you accept the warning.
This command does not work on Private, Loop, NPIV, and FICON devices.
Values include:
Specify the slot number for slot-bases switches.
For directors, use slot/port format for specifying the port number.
Specify all E_ports in the switch.
switch:admin> authutil --show
AUTH TYPE HASH TYPE
--------------------------------------
fcap,dhchap sha1,md5
switch:admin> authutil --set -a dhchap
Authentication is set to dhchap.
switch:admin> authutil --set -a all
Authentication is set to fcap,dhchap.
switch:admin> authutil --set -g 3
DH Group was set to 3.
switch:admin> authutil --set -g "*"
DH Group is set to 0,1,2,3,4
switch:admin> authutil --authinit 0/s1, 0/2
GROUP TYPE
0,1,2,3,4
2
authUtil
41