Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 237

This command is supported only on Brocade FR4-18i blades and Brocade 7500 platforms.
Operands This command has the following operands:
--slot slotnumber
-unit number
0
1
2
-path mode
1
2
3
-nframes count
Examples To test slot 2 with FC Router FPGA Serdes loopback sending 10 frames:
Diagnostics When a failure is detected, the test might report one or more of the following:
DATA
ERRSTAT
INIT
PORTDIED
STATS
TIMEOUT
XMIT
See Also fcrChipTest, miniCycle, portLoopbackTest
Fabric OS Command Reference Manual
53-1000436-01
RANDOM0x25, 0x7f, 0x6e, 0x9a, ...
Specifies the slot number on which the diagnostic operates. The default is 0
and operates on fixed-port-count products.
Specifies the FC Router FPGA to test. By default, all FC Router FPGA in the
specified slotnumber are used. Valid number values include:
FC Router FPGA 0
FC Router FPGA 1
All FC Router FPGA
Specifies the loopback point for the test. By default, fcrPathTest uses central
ASIC loopback. Valid mode values include:
Central ASIC loopback
FC Router FPGA Serdes loopback
FC Router FPGA internal loopback
Specifies the number of frames to send. The test progresses until the
specified number of frames are transmitted on each port. The default value is
10.
switch:admin> fcrpathtest --slot 2 -path 2 -nframes 10
Running fcrpathtest ..............
Test Complete: fcrpathtest Pass 10 of 10
Duration 0 hr, 0 min & 18 sec (0:0:18:942).
passed.
2
fcrPathTest
205