Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 136

2
configure
Zoning Operation Parameters
The Zoning Operation Parameter field is as follows:
Disable NodeName Zone Checking
Specify 1 to disable using node WWN when specifying nodes in the zone database, or specify 0 to
enable using node WWN when specifying nodes in the zone data. The default value is 0. This value
must be set to 1 for interoperability.
RSCN Transmission Mode
The RSCN Transmission Mode fields are described in Table .
TABLE 5
Field
End-device RSCN Transmission Mode
Domain RSCN to End-device for switch IP address or name change
End-device RSCN Transmission Mode
0
1
2
Domain RSCN to End-device for switch IP address or name change
0
1
Arbitrated Loop Parameters
The Arbitrated Loop Setting fields are described in the table.
TABLE 6
Field
Send FAN frames?
Enable CLOSE on OPEN received?
Always send RSCN?
Descriptions of the Arbitrated Loop Parameter fields are as follows:
Send FAN frames?Specifies that fabric address notification (FAN) frames be sent to public loop
devices to notify them of their node ID and address. When set to 1, frames are sent; when set to 0,
frames are not sent.
Enable CLOSE on OPEN received?
If this is set, a CLS is returned immediately to an OPN if no buffers are available. This is required for
TachLite.
104
RSCN Transmission Modes
Values are as follows:
RSCN only contains single PID
RSCN contains multiple PIDs
Fabric addresses RSCN
Values are as follows:
Disabled. No domain RSCN is sent to the end-device for the switch IP address or name change.
Enabled. Domain RSCN is sent to the end-device for the switch IP address or name change.
Configure Command Arbitrated Loop Settings
Type
number
number
Default Range
1 0 or 1
4 0 to 4
0 0 or 1
Fabric OS Command Reference Manual
Default Range
1 0 to 2
0 0 to 1
53-1000436-01