Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 141

-spd_mode mode
-norestore mode
-ports itemlist
Examples To run a functional test of all the ports on a switch:
See Also camTest, centralMemoryTest, cmemRetentionTest, cmiTest, itemList, portLoopbackTest,
portRegTest, spinSilk, sramRetentionTest
Fabric OS Command Reference Manual
53-1000436-01
Specify the speed mode for the test. This parameter is used only for Bloom
and Condor ASIC-based products, for which it controls the speed at which
each port is operated. For 1 Gbit/sec-only products it is ignored. The exact
operation of each mode 5 through 8 depends upon the loopback mode
selected. When speed modes 5 through 8 are used with cables, they must be
connected even to odd or the test will fail. Valid values are:
0 Run test at both 1 Gbit/sec, 2 Gbit/sec, and 4 Gbit/sec (default).
1 Set all port speeds to 1 Gbit/sec.
2 Set all port speeds to 2 Gbit/sec.
4 Set all port speeds to 4 Gbit/sec.
For -lb_mode set to 0 or 1, the following speed modes is available to test the
speed negotiation:
5 Set all even ports speed to AN; set all odd ports speed to 1 Gbit/sec.
6 Set all even ports speed to AN; set all odd ports speed to 2 Gbit/sec.
7 Set all odd ports speed to AN; set all even ports speed to 1 Gbit/sec.
8 Set all odd ports speed to AN; set all even ports speed to 2 Gbit/sec.
For -lb_mode set to 2 or 3, the following speed modes are available to test
FIFO underrun:
5,7 Set all even ports speed to 2 Gbit/sec; set all odd ports speed to 1 Gbit/sec.
6,8 Set all even ports speed to 1 Gbit/sec; set all odd ports speed to 2 Gbit/sec.
Specify 1 to force the test to skip part of the POST cleanup normally
performed. This might be helpful during debug. This parameter should
normally be left at the default value of 0.
Specify a list of user ports to test. By default, all the user ports in the current
switch will be used. Refer to itemList for more information.
switch:admin> crossporttest -ports 1/0-1/15
Running crossporttest ..............
Ports Segmented (0)
Executing test ...
Test Complete: crossporttest Pass 10 of 10
Duration 0 hr, 0 min & 8 sec (0:0:8:725).
passed.
2
crossPortTest
109