Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 497

vc_translation_link_init
desired_distance
Examples To configure a switch port 63 to support a 100 Km link and be initialized using long-distance link
initialization protocol:
See Also configure, portCfgISLMode, portCfgTrunkPort, portCfgShow, portShow, switchShow
Fabric OS Command Reference Manual
53-1000436-01
Specifies the long-distance link-initialization sequence; 1 activates and 0
deactivates this mode. When the command is run without specifying a value,
1 is assigned automatically for the long-distance link in VC_RDY flow control;
otherwise, 0 is assigned. This operand is optional.
Refer to the "Description" section for information about the value.
switch:admin> portcfglongdistance 4/15 LS 1 100
switch:admin> portshow 4/15
portCFlags: 0x1
portFlags: 0x20001
portType: 1.1
portState: 2 Offline
portPhys: 4 No_Light
portScn: 0
portId: 013f00
portWwn: 20:3f:00:60:69:00:02:48
Distance: super long <= 100km
portSpeed: 2Gbps
Interrupts: 9
Unknown: 0
Lli: 9
Proc_rqrd: 0
Timed_out: 0
Rx_flushed: 0
Tx_unavail: 0
Free_buffer: 0
Overrun: 0
Suspended: 0
Parity_err: 0
2_parity_err: 0
CMI_bus_err: 0
PRESENT LED
Link_failure: 0
Loss_of_sync: 0
Loss_of_sig: 9
Protocol_err: 0
Invalid_word: 0
Invalid_crc: 0
Delim_err: 0
Address_err: 0
Lr_in: 0
Lr_out: 0
Ols_in: 0
Ols_out: 0
portCfgLongDistance
Frjt: 0
Fbsy: 0
2
465