Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 537

enable
Tx & Rx
reject
busy
ctin
ctout
errlog
loopscn
OLP
LIP
LIM
BMP
OLD
TMO
Codes used in various fields are as follows:
state
Fabric OS Command Reference Manual
53-1000436-01
Mode: 0 normal; non-zero loopback
Header words 0,1,4 (R_CTL,D_ID,S_ID,OX_ID,RX_ID) and the first payload
word
FC-PH reject reason
FC-PH busy reason
Argument 0 is divided into two 16-bit fields:
[A] a bit map indicating whether subsequent args are valid (0001 means
argument 1 is valid, 0003 means arguments 1 and 2 are valid).
[B] the CT-based service command code.
Argument 1 is the first word of the CT payload, if applicable (as specified in
[A]).
Argument 2 is the second word of the CT payload, if applicable (as specified
in [A]).
Argument 0 is also divided into two 16-bit fields:
[A] a bit map indicating whether subsequent args are valid (0001 means
argument 1 is valid, 0003 means arguments 1 and 2 are valid).
[B] the CT command code indicating whether an accept (8002) or a reject
(8001).
If [B] is an accept, argument 1 and 2 represents the first and second words of
the CT payload, if applicable (as specified in [A]).
If [B] is a reject, argument 1 contains the CT reject reason and explanation
code.
Error type (refer to errShow)
The meaning further depends on each loop state:
Offline reason code, usually zero
Reason code for LIPs initiated by FL_Port, if the code value is 800x (x =
[1,0xc], see below), or the lower two bytes of the LIP received, if the code
value is other than 800x
Usually zero
Memory address for the loop bitmap
Usually zero
Encoded value of the state when loop init timed out This value is usually
equal to the first word of a loop init frame payload. Other possible values
include:
2 LIP (req. INITIALIZING) timeout
94F0F0ARB(F0) timeout
40 CLS timeout
2
portLogShow
505